> TROUBLESHOOTING > When the watch is unable to receive GPS signals

When the watch is unable to receive GPS signals

Points to be checked

When the watch does not start receiving or is unable to receive GPS signals even with operation of GPS signal reception, the following can be considered.

Reception is not started even with operation of GPS signal reception (time zone adjustment/manual time adjustment).

Check the indicator hand position.

batsu Reception is not allowed

Indicator display

Charging status

In-flight mode (plane_w)

low

Operation

Push Button B and release

Pull out the crown to the first click

Display

3X62_S_ind_low
3X62_S_ind_flight

Solution

Charge the watch by exposure to light until the indicator hand points to the “middle” position or “full” position.

Reset the in-flight mode (plane).

Reception is not possible even with operation of GPS signal reception (time zone adjustment/manual time adjustment) (The reception result is displayed as “N.”)

Move to a place where GPS signals can be easily received.
Place where GPS signals can be easily received/Place where GPS signals cannot be received

The seconds hand stops at the 45-second position before the reception is completed (The watch enters the power save 2 state)

If GPS signal reception is performed under low temperatures (0°C or less) in a state where the charging capacity and/or charging efficiency are lowered, the reception will be stopped, and the watch may enter the power save 2 state.
GPS signal reception consumes a significant amount of energy. Keep in mind to charge the watch regularly by exposure to light.How to charge the watch
If this occurs frequently, consult the retailer from whom the watch was purchased.