How to use tri-fold type clasp for leather band (Special clasps)

There are 3 types of special clasps as described below;

If the clasp of the watch you purchased is one of them, please refer to the indications.

A Type

Fixed loop

Movable loop

Buckle

Flap

Remove the pin from the adjustment hole. Slide the band left and right, and reinsert the pin into the adjustment hole at an appropriate length.

Adjustment hole

Do not push the flap in too hard.

When fastening the clasp, insert the tip of the band into the movable loop and fixed loop, and then, securely tighten the clasp.

While pressing the push buttons on both sides of the flap, lift to open the clasp.

Push button

Remove the pin from the adjustment hole. Slide the band left and right, and insert the pin into the adjustment hole at an appropriate length. Push the buckle and fasten the clasp.

Buckle

Adjustment hole

While pressing the push buttons on both sides of the flap, pull the band out of the movable loop and fixed loop. Then open the clasp.

Fixed loop

Movable loop

Buckle

Flap

Push button

Place the tip of the band into the movable loop and fixed loop, and fasten the clasp by pressing the frame of the buckle.

While pressing the push buttons on both sides of the flap, pull the band out of the movable loop and fixed loop. Then open the clasp.

Fixed loop

Movable loop

Buckle

Flap

Push button

Pull the pin out of an adjustment hole of the band. Slide the band to adjust its length and find an appropriate hole. Place the pin into the hole.

Adjustment hole

Adjustment hole