Dear Valued Customers of the Seiko Astron Watch
Instructions for Receiving Leap Second Data on
Seiko Astron GPS Solar Watch
Thank you for purchasing a Seiko Astron Watch.
Seiko Astron enters the “leap second data” receiving mode after the first GPS signal is received on or after December 1st and June 1st. This process occurs automatically so no special operation is required from the user. The process of receiving the leap second data takes longer than the regular time adjustment. Be sure to complete receiving the leap second data in an environment where a GPS signal can be received, such as outdoors.
The process of receiving leap second data
Although this movement is different from the normal time display,
it is not an indication that the watch is defective.
When the second hand points to the one-second position, it is indicating that one minute is required before the watch begins receiving the leap second data. At this time, it is recommended that you remain in an environment where a GPS signal can be received, such as outdoors.
The watch will repeatedly enter the “leap second data” receiving mode until the process is successfully completed. During this time, no time adjustment will take place. In the event that the attempt to receive leap second data is unsuccessful, indicated by position N (not successful), it is recommended you move to a place where a GPS signal can be easily received, such as outdoors, and complete the process of receiving time data and then leap second data through a GPS signal by pressing and holding button B for 3 seconds.
For details, please read the Basic Manual (Page 18).
About Leap Second
The leap second is to compensate for deviations from the “Universal Time” (UT) which is astronomically determined and the “International Atomic Time”(TAI). 1 second may be added (deleted) once a year or every few years at the end of June or December.